tag:blogger.com,1999:blog-6539093728798325673.post6180011958940729071..comments2018-07-19T18:29:39.437-07:00Comments on CubeX 3D Printing Blog: Print bed leveling aidcubeX-3D-printmanhttp://www.blogger.com/profile/16386814853378553046noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-6539093728798325673.post-56946376792656414872013-05-22T14:26:15.023-07:002013-05-22T14:26:15.023-07:00The problem is that the screw head for the front l...The problem is that the screw head for the front leveling screw is covered by the print bed, so you cannot turn or adjust it with the print bed in place. The two nuts screwed from the bottom onto that leveling screw and tightened against each other and therefore locking onto the screw, will now give you a way to turn the leveling screw with a 8mm wrench from the bottom. Make sure to loosen the Lock nut.cubeX-3D-printmanhttps://www.blogger.com/profile/16386814853378553046noreply@blogger.comtag:blogger.com,1999:blog-6539093728798325673.post-23015663589191199652013-05-22T13:58:31.678-07:002013-05-22T13:58:31.678-07:00Hi, I didn't quite follow your paragraph above...Hi, I didn't quite follow your paragraph above:<br /><br /> "Now, when you can hold the ..." what were you trying to say? What exactly is the problem that you're solving here?<br /><br />Thanks!amfhttps://www.blogger.com/profile/00365380162135862932noreply@blogger.com