Friday, October 4, 2013

Another new Software version: 1.06

Software version 1.06 just got released, shortly after the 1.05 release.  - SEE NOTE below !

NOTE:  Maybe you want to wait downloading this version there might be a bug that can cause a filament flow error.
I am getting a bad printfile when using jet 2 or jet 3.

See Release notes for changes.
Release notes:
Software 1.06 Release notes PDF

CubeX Maintainance document:
CubeX Maintainance check PDF

(Note: If you get an message "you do not have privileges to install etc....." during the install, try the install again by right clicking on the setup.exe file and select "Run as administrator".

 Installation Instructions:
- Uninstall previous installation of CubeX Software.
- Extract the folder
- Double click on setup.exe to begin installation
- The installer will direct thru the install process
- after installation complete, a CubeX Shortcut will be placed on the Desktop

Link to download new software version:

1 comment:

  1. Yes, the 1.06 has bug and has been reported to 3D Systems. They will issue a patch/update on or before early next week. So everybody, just wait.


Note: Only a member of this blog may post a comment.