Monday, May 20, 2013

Natural PLA Vase print

I like the look of the natural PLA.
Just finished printing this beautiful vase.
It printed super nice, no model clean up needed.
I just added a large round "helper pad" at the bottom for good print pad adhesion and stability. (it was needed since the bottom of the original model had only a few contact points to the platform)
Print settings: 0.25 Resolution, Hollow fill, No support, no raft. Fine detail not checked.
18h 19min, 128 gram

Here is the model file:
vase zipped file download

1 comment:

  1. looks awesome Rick!
    that is a cool material!
    nice going!


Note: Only a member of this blog may post a comment.